|
CLOSED
Leaves are parallel, together and at the 0° position. |
|
|
|
FLAT
Leaves are in line, at the 180° position. |
|
|
|
BOTH LEAVES HALF-SWAGED
Both leaves are swaged approximately one-half the pin diameter with a minimum clearance between leaves when parallel. |
|
|
|
ONE LEAF HALF-SWAGED
One leaf swaged one-half the pin diameter. |
|
|
|
ONE LEAF FULL-SWAGED
One leaf swaged equal to the pin diameter and both leaves parallel when closed. |
|
REVERSE SWAGED
One leaf swaged to simulate reverse assembly. Leaves will not close to a parallel position. |
|
REVERSE ASSEMBLY |
|
| ONE LEAF FORMED UP 90 DEGREES |
|
|
| ONE LEAF FORMED DOWN 90 DEGREES |
|
|
|
MULTIPLE PIN HINGES
Multiple pin hinges for double action. Available in Reverse Assembly, Swaged and formed configuations. |
|
|
|
LENGTH
The length of the leaves measured lenthwise to the pin. OPEN WIDTH The overall dimension of the leaves measured across the pin. LEAF That portion of a hinge extending away from the knuckle at 90° to the pin. LEAF WIDTH The dimension from the center of the pin to the outer edge of the leaf. |
 |
|
KNUCKLE
The hollow circular part through wihch a pin is passed. (Also called curl.) KNUCKLE LENGTH The dimension of the knuckle measured parallel to the pin. PIN The rod running through the center of the knuckles. |
 |
[Main] [Marine Industry Items] [Hinge Terminology] [Stock Selection] [Contact]
Questions or comments specific to site? Email Webmaster.